Prep for Can Lights

Work for the can lights is underway!

We started by breaking out the CNC again. We cut four 12x96” wide strips of plywood and used the CNC to slice out six super-percise mounting holes in each:


Then, we cut sheets of 1” rigid insulation for each by and a series of side spacers. The insulation will act as a “cap” to each light and allow us to safely spray foam the interior of the structure once the electrical is finished:


Finally, we installed each strip of plywood end-to-end, capped off every other spacer, and glued in the side bracing for the bays which will contain a light:

view b

This is more of a preparation stage for the lights. Hopefully we will have them wired in this week.

Share This:

Stay up to date with our progress.

Subscribe to our newsletter and stay updated.